CDA-4D

Усилитель распределения

The CDA-4D is a compact distribution amplifier, designed to power current and future Bowers & Wilkins Custom Installation loudspeakers. Embedded DSP allows optimisation of a wide range of products and dynamic EQ for Bowers & Wilkins subwoofers. It boasts four channels of 125 watts each, and its full-rack-width 1U design delivers high-performance from minimum rack space.

To ensure the CDA-4D delivers in the modern custom installation system, it is equipped with Digital Signal Processing (DSP). This allows it to be used in wide variety of situations, provides control over IP and configuration, and for providing dynamic EQ for Bowers & Wilkins subwoofers.

CDA-4D's 1U size means that it takes up the minimum of rack real estate. But with four channels of 125 watts of Class D amplification on hand it can deliver power when required. Plus, as it's bridgeable this can be configured to 2 x 250 watts, or a 2.1 setup (2 x 125 watts and 1 x 250 watts), where needed.

Whether you are looking to upgrade an in-situ installation or planning a new one, the CDA-4D DSP amplifier is ideal. It can drive two zones, and works with a wide variety of Bowers & Wilkins products, both current and future.

• Load impedance range: >3Ω per channel (>6Ω in bridge mode)
• Output Power per channel, non-clipped: 60W into 8Ω, 125W into 4Ω (424W into 4Ω)
• Output Power bridge mode, non-clipped: 250W into 8Ω
• Output Power total, all channels: 500W short term, >125W continuous
• DC offset voltage: <50mV
• Frequency Response (-3dB): <10Hz to >30kHz, any load impedance
• Frequency response accuracy 20Hz-20kHz: +/-1dB
• Dynamic range: >85dB A-Weighted
• THD+N (1kHz, 500W, 40): less than 1%
• Voltage Gain: 15 dB to 39dB, adjustable
• Input impedance: 10kΩ
• Maximum input voltage: 4 Vrms
• Signal sense threshold: Wake-up time: 2.5mV (independent of Gain setting), <0.2s (If other zones active), <2s (From all zones inactive)
• Turn-off time: 15 minutes from last signal detected
• 12V trigger input threshold: Typically 3V (recommended input is 5-15V)